Brilix XHP 100 Guia do Utilizador

ENSWIMMING POOL HEAT PUMP(THP 55, THP 100, THP 120, THP 170)INSTALLATIONANDUSER GUIDEiRead the instructions

10VII. Connection diagramCONNECTION DIAGRAM FOR THE SWIMMING POOL THERMAL PUMPfour-way valvePOWER SUPPLY electricremotecontroltemperature of incoming

11OperationStandby VIII. Operating the control unitPreliminary steps before start-upA) Inspect the heat pump• Visually check the device or the pipeli

12NOTE: In order for the unit to be able to heat the swimming pool (or spa), the filtration pump must be in operation in order for water to be able to

13Currentmeasured valueParameter 18.3 How to change the modePress the button to change the mode to automatic, heating or cooling. The app

148.5 How to tell the current statusIf the heat pump is in operation, press to check the current status of the unit. You can checkthe temperatu

15d) To set the switch-off time of the timer, take the same steps. Instead of button use button .The green indicator light for the sw

169.7 Chemical composition of water in the swimming poolSpecial attention should be given to the chemical balance of water in the swimming pool. The w

176. Do not use the heat pump if it was flooded. Immediately contact a qualified specialist to check the pump and repair it if necessary.Condensation

18Problem Symptoms Possible cause SolutionThe heat pump is not working.The display does not light up and the ventilator/compressor is not emitting any

19Problem Symptoms Possible cause SolutionThe heat pump is not working.The display does not light up and the ventilator/compressoris not emitting any

2Contents I. Package content ... 3II. Performance and properties ...

20XII. Summary of error codes on the display (LED CONTROLLER)Protection / defectElectric remote controlCheck SolutionDefect to the temperaturesensor

21Protection / defectElectric remote controlCheck SolutionDefect to the flow switch.EE3 1. Check whether the cable connection to the flow switch is i

22 WARNING• Before installation, check that the electricity supply complies with the technical conditions of your heat pump. The details are specifie

3I. Package content① swimming pool heat pump② instructions③ 2 pieces of fitting④ display cover for placement on the wall⑤ spare display cover⑥ 4 piece

4III. System design• Heat pumps make use of free heat from the sun by collecting and absorbing energy from the outside air.• This device contains a

5IV. Performance propertiesPerformance properties of a monoblock-type heat pump for swimming poolsCode THP 55 THP 100 THP 120 THP 170Nominal heat outp

6V. DimensionsDimensions of heat pumps (monoblock-type) for swimming poolsVI. Preparations for installation6.1 Selection of the installation position•

7 WARNING:• Do not put your hand or any object into the air outlet or ventilator, as this could damage the device and cause an injury.• In the even

86.2 Fitting diagramheat pumpwater treatment side joining valveinput forpower cableoutputinputdischarge pipefor condensed water dischargespoutswimming

96.3 Electrical connectionIMPORTANT: The installation and connection of this device to the power supply can be provided only by authorized person acco